User's Manual
BHS-i100 Installation and Programming Instructions
22
their default configurations,
Communicator 1 is the central
station, Communicators 2-4 are
blank.)
Default value: Communicator 1: Blank
Communicator 2-4: Blank
To Configure: To change the account number of
Communicators 1 through 4, press
[\/] to scroll to the desired
Communicator number, and press
the [Enter] key to select the
Communicator Account Number
field. Press the [Enter] key again to
switch to the data- entry mode.
Input the appropriate account
number for the Communicator, then
press the [Enter] key to write the
number to memory.
To return to the Standard Menu,
press the [Esc] key.
To Skip: If you do not wish to change the
numbers, press the [\/] key to scroll
to the next menu item.
Information sought: What is the configuration of
Communicators 1 through 4?
Default value: Communicator 1: Alarm Receiver
Communicators 2 - 4: Unconfigured
To Configure: If you wish to change the
configuration of a Communication
Device, press the [Enter] key to
begin. You see:
1 Alarm Receiver
2 <Unconfigured>
3 <Unconfigured>
4 <Unconfigured>
Enter the number of the
communication device you wish to
edit or use the [\/] key to scroll to
the desired communicator. Press
[Enter] to select the device.
To change any of the settings,
follow the directions listed below.
You can use the [\/] key to scroll
through the programmable items.
When you reach the item to be
changed, press the [Enter] key to
switch to the data-entry mode.
Comm Type: Select the
appropriate communication
protocol for Communicator 1. The
only option is “SIA.”
Dial Area Code: specify the long
distance access code and the area
code that the system should dial to
reach the communicator. If it is a
long-distance call, include a “1”
here. The default is “1800.”
Dial Phone number: Specify the
telephone number that the system
should dial to reach the
communicator. The default is blank.
To select another communicator for
editing, press the [Esc] key. If you
wish to return to the Standard
Menu, press [Esc] twice.
Menu Item 2: Dial Prefix
Information sought: Are any special codes required
when placing a call?
Default value: Blank
To Configure: If you wish to change the Dial
Prefix, press the [Enter] key to
begin.
Enter the codes required when
connecting to an outside line.
Some of the common codes are:
Outside line from PBX - 8 or 9
5-second Pause - Comma (,)
Wait for Dial Tone – W
To Skip: If you do not wish to reconfigure the
communicators, press the [\/] key
to scroll to the next menu item.
Menu Item 3: Set Exit Delays
Information sought: Do you wish to program one exit
delay for all of the system’s
Keypads?
Default value: 80
To Configure: If you wish to program a global exit
delay, press the [Enter] key, input
the number of seconds the exit
delay will last, then press the
[Enter] key again to write the
change to memory
To Skip: If you do not wish to program a
global exit delay, press the [\/] key
to scroll to the next menu item.
Menu Item 4: Set Entry Delays
Information sought: Do you wish to program one entry
delay for all of the system’s
Keypads?
Default value: 40
To Configure: If you wish to program a global
entry delay, press the [Enter] key,
input the number of seconds the
entry delay will last, then press the
[Enter] key again to write the
change to memory.