User's Manual
BHS-i100 Installation and Programming Instructions
14
OK to overwrite
zone 12?
1=YES 2=NO
8. After the zone number has been selected, the Programmer
will display a list of zone types such as:
Zone #
Type
? INSTANT
9. The process may be repeated until all Sensors are
registered.
10. Use the Programmer’s Zone Finder to ensure that all
sensors are correctly registered.
2.13 Supervision
Supervised Sensors and Transmitters send check-in signals to
the receiver at 70-90 minute intervals.
If at least one check-in message is not received from each
transmitter within the specified supervision period, the icon
Keypad will display “TROUBLE” along with the associated
zone number.
2.14 Battery Life Indication
Batteries in InGrid Sensors typically last 9 to 10 years, and
batteries in Ademco Transmitters may last from 2 to 4 years,
depending on the environment, usage, and the specific wireless
device being used. Factors such as humidity, extreme
temperatures, as well as large temperature variations, may all
reduce the actual battery life in a given installation.
The wireless system can identify a true low-battery situation,
thus allowing the dealer or user time to arrange a change of
battery and maintain protection for that given point within the
system.
A low battery condition is noted when the display shows
“LOW BAT”.
InGrid Sensors contain long-life but non-replaceable batteries,
and no battery installation is required. At the end of their life, the
complete unit must be replaced and registered by the
Programmer. Do not install batteries in Ademco Transmitters
until you are ready to register them during system programming.
2.15 Learn Key Fob
1. Using the Programmer, navigate to “Learn Devices”, then
“Learn Key Fob”. Registration will be enabled for 60
seconds only. The Programmer will display:
Press any Key Fob
Button 3 times
2. While holding the Keychain Remote near the Programmer
(within 1 foot is preferred), press any Keychain Remote
button 3 times. The Programmer and the Keypads will triple
beep. If successful, the Programmer will display:
Key Fob detected
Press any Key Fob
Button 3 times
To qualify
3. If the Keychain Remote fails to transmit within 60 seconds,
the Programmer will leave registration mode automatically.
If a system detects two different Keychain Remote bursts
during the Keychain Remote registration mode it will not
register either Keychain Remote and the Programmer will
leave registration mode automatically.
4. The registration must be confirmed by pressing any
Keychain Remote button 3 times. The Programmer will then
display either:
Key Fob QUALIFIED
Press any key to continue
or
Key Fob NOT QUALIFIED
Press any key to continue
5. If the Keychain Remote fails to qualify, the Programmer will
return to the “Learn Devices” menu.
6. If the Keychain Remote successfully qualifies, the
Programmer will display:
Enter User Number:
> <default>
7. The installer may enter a new number, or press [Enter] to
select the default user number value. Note that the
Keychain Remote will only become active if the
selected user number is enabled. A Keychain Remote
cannot be added to users 9-13. If the installer enters a
user number which is currently in use, the Programmer will
display:
OK to overwrite
User 2?
1=YES 2=NO
8. After the user number has been selected, the Programmer
will display a list of button definitions such as:
Enter Button 1 type:
> POLICE
9. The process may be repeated until all Keychain Remotes
are registered.