User's Manual

This equipment is designated to be connected to the telephone network or premises wiring
using a compatible modular jack (RJ31X) which is part 68 compliant.
A plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements adopted
by the ACTA. A compliant telephone cord and modular plug is provided with this product.
It is designed to be connected to a compatible modular jack that is also compliant. See
installation instructions for details.
If this equipment (Model BHS i-100) causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service may be
required. But if advance notice isn't practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could aff
ect the operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to make necessary modifications to
maintain uninterrupted service.
If trouble is experienced with this equipment (Model BHS i-100), for repair or warranty
information, please contact Brinks Home Security Customer Care at [phone] or
visit www.mybrinks.com and select the Frequently Asked Questions link. If the equipment
is causing har
m to the telephone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
Connection to party line service is subject to tariffs. Contact the state public utility
commission, public service commission or corporation commission for information. This
equipment m
ust not be used on party lines.
This equipment is hearing aid compatib
le.
ii 47
Alarm Permits
Your local municipality may require you to obtain an alarm permit
before you can operate the Brink’s Home Security system. Please
contact your city or county police department to determine the
requirements in your area. For more information, visit
www.mybrinks.com.
Caution
To ensure proper operation, this equipment must be installed
according to the installation instructions. To verify that the
equipment is operating properly and can successfully report an
alarm, this equipment must be tested immediately after installation,
and periodically thereafter, according to the enclosed test
instructions.
Caution
In order for "alarm dialing equipment" to be able to seize the
phone line to report an alarm or other event when other customer
equipment (telephone, answering system, computer modem, etc.)
connected to the same line is in use, "alarm dialing equipment"
must be connected to a properly installed RJ31X jack. The RJ31X
jack must be connected in series with, and ahead of, all other
equipment attached to the same phone line. Series installation of
an RJ31X jack is depicted in the figure below. If you have any
questions concerning these instructions, you should consult your
telephone company or a qualified installer about installing the
necessary jack and alarm dialing equipment for you.
BrinksKeyPadPrinterSprd.2.22.06 2/22/06 3:06 PM Page 8