User's Manual

ii
System Options
The system has five options:
1) bypass
2) door chime
3) auxiliary codes
4) alarm memory
5) test
This section describes each of these five options.
How to Bypass a Zone
When you bypass a zone, the system ignores it. Use this whenever you want
to turn the system on, but leave a particular sensor off. The bypass is
automatically canceled when you turn the system off.
To bypass a zone, do the following:
21
1. Press the OPTIONS key until the message window
displays: BYPASS, ENTER ZONE #.
2. Enter the number of the zone you wish to bypass.
The keypad beeps. The message window displays
READY, BYPASS. The number of the bypassed
zone lights momentarily.
BYPASS ENTER
ZONE #
NOT READY ALL ON INSTANT
DOOR CHIME NO AC MOTION OFF
TROUBLE TEST LINE CUT LOW BATT
ALARM MEMORY AUXILIARY CODES
CANCELED BYPASS ENTER MASTER USER
:
I
:
I
:
CALL 800-445-0872 ZONE
:
I
:
I
:
NEW CODE
How to Delete an Auxiliary Code
If you wish to delete an auxiliary user code, do the following:
24
1. Press the OPTIONS key until the message window
displays: AUXILIARY CODES, ENTER
MASTER
CODE
.
2. Enter the master user code.
The keypad beeps. The message window displays:
ENTER USER #.
3. Enter the number of the user whose code you wish
to delete.
The keypad beeps. The window displays: ENTER
NEW CODE.
4.
Do not enter the user’s code. Instead, press the
CANCEL key.
The keypad beeps.
5. Test that the code has been deleted by attempting
to turn the system on and off, using the deleted
code.
AUXILIARY
CODES ENTER
MASTER CODE
USER NUMBER
NOT READY ALL ON INSTANT
DOOR CHIME NO AC MOTION OFF
TROUBLE TEST LINE CUT LOW BATT
ALARM MEMORY AUXILIARY CODES
CANCELED BYPASS
ENTER MASTER USER
:
I
:
I
:
CALL 800-445-0872 ZONE
:
I
:
I
:
NEW CODE
BrinksKeyPadPrinterSprd.2.22.06 2/22/06 3:06 PM Page 54