User's Manual

ii
System Testing
You can test the components of the system—the sirens, the telephone hook-
up, and the sensors—without causing a false alarm. This section describes
how you can be sure that the system is functioning properly.
Siren and Transmission Test
This test helps to ensure that the system’s siren is working properly, and that
the system is able to send an alarm signal to the Brink’s Monitoring Center.
You will not receive a call from Brink’s.
To test the system’s siren and transmission, do the following:
25
Important Notice: Test Weekly
Your Protective Service Agreement requires you to conduct
these tests every week.
1. Press the OPTIONS key until the message window
displays: TEST, ENTER CODE.
2. Enter your code.
The message window displays: TEST. A test signal
is sent to Brink’s. If it is received, the keypad siren
sounds briefly.
3. If you do not hear the beep or blast, and the
keypad message window displays CP TROUBLE,
the test failed. Call 1-800-445-0872.
TEST
, ENTER
CODE
CODE
NOT READY ALL ON INSTANT
DOOR CHIME NO AC MOTION OFF
TROUBLE TEST LINE CUT LOW BATT
ALARM MEMORY AUXILIARY CODES
CANCELED BYPASS ENTER
MASTER USER
:
I
:
I
:
CALL 800-445-0872 ZONE
:
I
:
I
:
NEW
CODE
Turning the System Off After an Alarm in Your Absence
Follow these instructions if there was an alarm at your house while you were
away and the sirens are no longer sounding.
20
1. Enter the building through a designated entry door.
The ON light blinks. The sirens and speakers are
silent. The keypad shows the numbers of the zones
in alarm and its message window displays ALARM.
2. Enter your user code to turn the system off. The
keypad beeps repeatedly. The keypad shows the
numbers of the zones that were in alarm and
displays ALARM MEMORY.
3. Refer to the Pop-Up Grid Identification Card to verify
the location of the zones that were in alarm.
4. To silence the keypad’s beeping and clear
Alarm Memory, press the CANCEL key.
5. If you do not know what caused the alarm, review
the system’s alarm history at
www.mybrinks.com or
call Brink’s Customer Care at 1-800-445-0872.
BrinksKeyPadPrinterSprd.2.22.06 2/22/06 3:06 PM Page 52