User's Manual

ManualsBrandsLifeShield ManualsElectronicsWireless Security Sensor

Testing the Doors and Windows Only continued

*Note: The keypad does not beep if the chime feature has been turned off by

the installer. Both the keypad and grid extender can be configured by the

installer to beep.

1. Close all doors and windows. Make sure the

message window displays READY. (If it does not,

see page 29.)

2. Press the OPTIONS key until the message window

displays: DOOR CHIME.

3. Enter your code.

The message window displays READY DOOR

CHIME

4. Open each protected door and window, listen for

the keypad and grid extender to beep.*

5. If you do not hear the keypad beep, note the

zone number and call Customer Care at

1-800-445-0872.

6. When you have finished testing, end the test by

repeating steps 2 and 3.

DOOR CHIME

READY DOOR

CHIME

NOT READY ALL ON INSTANT

DOOR CHIME NO AC MOTION OFF

TROUBLE TEST LINE CUT LOW BATT

ALARM MEMORY AUXILIARY CODES

CANCELED BYPASS ENTER MASTER USER

CALL 800-445-0872 ZONE

NEW CODE

6. To turn the system on, you must first turn off the

zone that is not ready to arm. Press the OPTIONS

key until the message window displays: BYPASS,

ENTER ZONE #.

7. Enter the number of the not-ready zone, the same

number that appeared in the message window.

CAUTION: If you bypass a zone, it will not be

protected.

The keypad beeps. The message window displays

READY, BYPASS and the number of the bypassed

zone is momentarily displayed.

8. Turn the system on.

BYPASS

ENTER ZONE

ZONE

NUMBER