User's Manual

ManualsBrandsLifeShield ManualsElectronicsWireless Security Sensor

Testing With Not Ready Zones

If the system is not ready to test, the message window displays NOT READY.

Do the following:

1. Observe which zone number is displayed. This is

the zone that is not ready.

2. Refer to the Pop-Up Grid Identification Card to

verify the location of the zone.

3. If the zone is a door or window, make sure that it is

securely closed.

4. If the message window now displays READY

conduct the test.

5. If the message window still displays NOT READY,

call Customer Care at 1-800-445-0872 for

assistance.

READY

NOT READY ALL ON INSTANT

DOOR CHIME NO AC MOTION OFF

TROUBLE TEST LINE CUT LOW BATT

ALARM MEMORY AUXILIARY CODES

CANCELED BYPASS ENTER MASTER USER

CALL 800-445-0872 ZONE

NEW CODE

Turning the System On When It Is Not Ready

If the system is not ready to turn on, the message window of your keypad

displays NOT READY. This message could mean, for example, that one of the

protected windows in your house is open.

If you press the ON key when the system is not ready to turn on, the keypad

sounds an error tone and the system does not turn on.

To make the system ready to arm and to turn it on, do the following:

1. Observe the number displayed in the message

window. This is the zone that needs to be corrected

before the system will turn on. (There may be more

than one, if so, the numbers are shown one at a

time.)

2. Refer to the Pop Up Grid Identification Card to

verify the zone’s location.

3. If the zone is a door or window, make sure that it is

securely closed.

4. If the message window displays READY, turn the

system on.

5. If the message window displays NOT READY, see

the Frequently Asked Questions information at

www.mybrinks.com or call Customer Care at

1-800-445-0872 for further assistance in correcting

the not ready condition.