User's Manual

Trouble Messages
You will get a trouble message if the system loses power, if it cannot reset the
smoke detector, or if it cannot contact the monitoring center.
1. Observe which of the keypad’s icons, numbers or words are
displayed, and note any letters that may appear in the numeric
display. Match the keypad’s message to the table below, then turn
to the section listed in the table’s second column for further
information and instructions.
30
Messa
ge Trouble Condition Page
CALL 800-445-0872 Call Brink’s Indication 36
CF TROUBLE Component Failure Indication 36
CP
TROUBLE Communication Problem Indication 34
CS TROUBLE Siren Failure Indication 36
CH TROUBLE Upload/Download Failure 35
LINE CUT Line Cut Indication (optional feature) 35
LOW BATT Low Battery Indication 32
NO AC No AC Power Indication 31
TROUBLE Zone # (Beeping) Zone Trouble Indication 36
TR
OUBLE OP (Beeping) Zone T
rouble Indication
36
15
Turning the System On with Motions Turned Off / Instant Mode
Turning the System On in Instant Mode
1. Close all of the doors and windows and make
sure that the message window displays READY.
(If not, see page 16.)
2. Press the ON key.
3. Press the MOTION OFF key.
4. Press the INSTANT key.
The ON light turns on. The keypad displays ON,
MOTION OFF, and INSTANT.
Do not leave the building, or open any
protected windows without first turning the
system off.
1. Close all of the doors and windows and make
sure that the message window displays READY.
(If not, see page 16.)
2. Press the ON key.
3. Press the INSTANT key.
The ON light turns on. The keypad displays ALL
ON, INSTANT.
Do not leave the building, open any
pr
otected windows, or move in front of the
motion detector without fir
st turning the
system off.
BrinksKeyPadPrinterSprd.2.22.06 2/22/06 3:06 PM Page 42