User's Manual Part 1

USING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[54]
Exit and Entry Delay Tones/Alarms
Exit and Entry Delay Tones will be generated based on the arming mode of your system as shown in Table 2.
Editing Exit and Entry Delay Tone (LifeShield.com)
Exit or Entry Delay tone on an individual GC can be changed
(Figure 31):
1. Go to www.LifeShield.com
2. Enter your User Name and Password
3. Click Settings tab, then Grid Controllers and Handsets
4. Click Edit, adjacent to desired GC
5. Click Yes or No to enable or disable the tone
6. Click Continue
7. Click Submit when requested
Arm Mode Exit Tone Entry Tone
Stay No Yes
Instant Stay No Delay No Delay
Away Yes Yes
i
Messages will only be sent to the
Alarm Monitoring Center for alarm
monitoring subscribers when the
system is activated and an
alarm occurs.
Alarms
An Alarm Siren will sound when the following occurs:
• When the system is armed, a Sensor has been opened and the Entry delay (if applicable) has expired.
• A PANIC button has been pressed on the Handset, Console or Keychain Remote.
• A Siren Detector or Smoke Sensor detects a siren sound or smoke.
Alarm Notification Delay (Alarm Monitoring Subscribers Only)
When an Alarm Siren sounds, a message will be sent to the Alarm Monitoring Center after a delay of 30 seconds. This feature
minimizes false dispatch of the authorities to your home. If an alarm sounds accidentally, you can cancel the alarm during this
delay time by pressing CANCEL/OFF and entering your User Code.
If you do not subscribe to Alarm Monitoring Service or your service is not active, and your system is armed, your Handset and
Console display will indicate “No Dispatch.”
PHNBK MENU
ALARMED
Sensor Name
Calls: 0 Msg:0
Figure 31. LifeShield Edit Grid Controller and Handset Screen - Entry Delay Tone
Table 2: GC Exit and Entry Delay Tone Settings