User's Manual Part 1

Bypassing Sensors
USING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[51]
Bypassing a Sensor allows you to arm the system without monitoring or creating an alarm condition when a Sensor is opened or already open. The Sensor
remains bypassed only until the system is armed and disarmed and cannot be permanently bypassed. A Sensor can be bypassed on your Handset, Console
or LifeShield.com.
Bypassing an Open Sensor (Handset/Console)
If the system display reads Not Ready to Arm, a Sensor is open. You can restore the system to the Ready to Arm state by either bypassing the open Sensor
or closing the Sensor.
Bypass a Sensor by following these steps:
BACK BYPASS
Not Ready To Arm
Open:Sensor Name
Calls: 0 Msg:0
PHNBK MENU
Armed xxxx
Bypass On
Calls: 0 Msg:0
BACK SELECT
Bypass Sensors
All
Sensor Name
1. Press BYPASS
2. The Bypass Sensors screen appears with the list of
open Sensors
3. Scroll and select the Sensor(s) you would like to bypass.
Bypassing Closed Sensors (Handset/Console)
Prior to arming your system, you can bypass closed Sensors on the Handset or Console:
1. Press MENU
2. Scroll to Security Setup, press SELECT
3. Enter your Master Code, press SELECT
4. Scroll to Bypass Sensors, press SELECT
5. Scroll to desired Sensor you would like to bypass, press SELECT
Bypassing an Open Sensor (LifeShield.com)
When a Sensor is opened, the Sensor Status window on the Security tab will indicate the name of the open Sensor.
To bypass a Sensor (Figure 28):
1. Go to www.LifeShield.com
2. Enter your User Name and Password
3. Navigate to Security tab then to Sensor Status
4. Check the box next to the Sensor that indicates open
5. Click Bypass Sensors
Turning Off Sensor Bypassing (Handset/Console and LifeShield.com)
Sensor Bypass can only be deleted by arming and disarming your system.
Figure 28. LifeShield -
Sensor Status