User's Manual Part 1

Arming/Disarming Your System
USING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[50]
Disarming Your System (LifeShield.com)
1. Go to www.LifeShield.com
2. Enter your User Name and Password
3. Click Disarm located in the Arm Status panel
4. Click Enter
Advanced Arming (LifeShield.com)
The system provides you with several advanced arming options, such as Auto Stay or One Touch Arming.
Auto Stay
Factory default for Auto Stay is Yes. If arming Away and a door Sensor does not open and close during the Exit Delay (you don’t leave the house), the system
will instead arm Stay and only Sensors defined for monitoring during arm Stay will be monitored (i.e., the Motion Sensor will be turned off). This prevents false
alarms as a result of you staying home.
If the Auto Stay is changed to No, the system will not require an exit during arming Away.
To change the Auto Stay selection (Figure 27):
1. Go to www.LifeShield.com
2. Enter your User Name and Password
3. Click Settings tab, then System Settings
4. Click Edit
5. Change the Auto Stay selection to No
6. Click Continue
7. Click Submit Changes when requested
One Touch Arming
The system can be set so that your User Code is not needed when arming. To set this mode,
change the One Touch Arming selection to Yes
(Figure 27):
1. Go to www.LifeShield.com
2. Enter your User Name and Password
3. Click Settings tab, then System Settings
4. Click Edit
5. Change the One Touch Arming selection to Yes
6. Click Continue
7. Click Submit Changes when requested
Figure 27. LifeShield System Settings Screen -
Edit Auto Stay/One Touch Arming