User's Manual Part 1

INSTALLING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[36]
Installing the Flood (Water) and Temperature Sensor
5. Follow the appropriate steps associated with the sensing type of the Sensor
a.) Temperature Sensor (Hot, Warm or Cold) sensing: Locate the mounting bracket where it will be most suit-
able for Temperature Sensing (for example on a wall, ceiling, etc.). Using either the supplied screws or
double-faced adhesive tape, secure the mounting bracket to a flat surface (wall or ceiling).
b.) Flood (water) sensing:
i. Locate the water probe assembly (with wires attached as shown) and mount it near the “baseline” surface
(ex. floor) using the supplied double-faced tape or suitable wall mounting screws (not supplied). It is
recommended that the probe be mounted between 0 to 1/8” above the baseline surface.
ii. Loop the free end of the Water Probe wire through the back of the wireless transmitter (as shown in
illustration) and connect the wire pair to the loop terminal block by inserting the wires (individually) into
the loop terminals and tightening the screws.
iii. Determine the best location to install the mounting plate above the
location where the Water Probe has been installed, being careful not to position it too high
(beyond the length of the wires now connecting the water probe and wireless transmitter).
iv. Using either the supplied screws or double-faced adhesive tape,
secure the mounting bracket to a flat surface (wall or ceiling).
6. Install the CR123 battery (supplied) into the wireless transmitter noting the correct orientation
of the positive (+) and negative (-) ends
7. Position the wireless transmitter over the mounting plate and slide the
wireless transmitter securely into place (until it “clicks”)
Note: Do not re-attach cover until you have
added this device to the LifeShield system
Battery