User's Manual Part 1

INSTALLING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[33]
Installing the Glassbreak Sensor
Install Glassbreak Sensor
1. Remove the Glassbreak Sensor and related components from the box and physically install the
device according to the manufacturer's printed instructions.
NOTE: It is important to follow the manufacturer's printed instructions regarding (a) connecting the
batteries, (b) adjusting the sensitivity, (c) selecting the location and (d) mounting the device prior to
moving on to the next step involving integration of this device with your LifeShield system. Please note
that it is not necessary to "Enroll" the device at this time.
2. Mount the Glassbreak Sensor to a flat surface and close the front cover.
A LifeShield system (including a
Base and at least one Handset
or Console) must be installed
before a Glassbreak Sensor
can be added.
i
If you require additional
assistance with setup or
installation, contact LifeShield
Customer Support at
1-888-392-2044.
i
Add the Glassbreak Sensor to the LifeShield System
Starting with the Glassbreak Sensor mounted to a flat surface with the front cover closed:
1. On the Handset or Console, press MENU
2. Scroll to Security Setup, press SELECT and enter the Master Code
3. Scroll to Sensors, press SELECT
4. Scroll to <Add New>, press SELECT
5. Scroll to Glassbreak, press SELECT
6. Following the instructions displayed on the LCD screen:
Wait 5 seconds then open the front cover of the Glassbreak Sensor ("Un-clip Sensor from
Bracket"). (You will have 30 seconds to complete this step.) When the Glassbreak Sensor has
successfully been added you will hear 4 fast confirmation beeps from the LifeShield system.
If there are no confirmation beeps, check to make sure that the battery insulator tab has been
removed and repeat the steps above.
Once the Glassbreak Sensor has been added to the LifeShield system:
7. Use the Edit feature to rename the device (if desired). Press DELETE to erase text and the keypad to type new a one.
8. Press OK, then press BACK until the Main Menu is displayed
9. Shut the front cover of the Glassbreak Sensor
Test the Glassbreak Sensor
1. On the Handset or Console, press MENU
2. Scroll to Utilities, press SELECT
3. Scroll to Test, press SELECT
4. Enter your Master Code
5. Select System Test
6. Press the SKIP soft key to skip the Siren Test
7. Press the OK soft key on next screen for Starting Comm Test
8. Scroll to the name of the Sensor that you would like to test, and press SELECT
9. Tap strongly on the front cover of the
Glassbreak Sensor
If the Glassbreak Sensor test is successful, the LCD screen will display "Sensor xxx Passed." If these words do not appear,
return to "Add the
Glassbreak Sensor
to the LifeShield System."