User's Manual Part 1

INSTALLING YOUR SECURITY SYSTEM

[www.LifeShield.com]

[23]

Installing the Sensor

If your window frame does not

provide enough room for

mounting the Bracket, you may

need to use a Sensor Extension.

See the Sensor Extension

section in the user manual.

9. Edit Sensor Name (Optional)

You may change the name now or at a later time.

• To change the Sensor Name, press the DELETE key

to remove the default name.

• Using the keys on your Handset keypad, type in the desired name.

Press OK when complete.

10. Sensor

Placement: Scroll to Door or Window. Press OK

11. Alarm Type: Scroll to Stay & Away, Away Only, or Convenience. Press OK

Stay & Away means the Sensor will be monitored in both Armed Stay and Armed Away modes (i.e. an exterior door). Away

Only means the Sensor will be monitored only in Armed Away mode (i.e. an interior door). Convenience means the Sensor is

only used for text messaging (like a liquor cabinet).

12. Sensor Extension

: Scroll to Sensor Only, Extension, or Both. Press OK

For standard Sensor installation with the Magnet next to the Sensor, select Sensor Only. A Sensor Extender is only

required if space does not permit the Sensor to be placed next to the Magnet. In this case, use the Sensor Extension pictured

below. You may also use the Sensor to monitor two windows by selecting Both. In this case, the Sensor monitors both a

Magnet next to the Sensor and another Magnet next to the Sensor Extension.

Sensor Extension

The Sensor Extension plugs into the small connector as shown (next to the where the battery cover hinges). The plug/connec-

tor are keyed so be careful when inserting the plug into the connector.

The Sensor Extension monitors a Magnet up to ¾ of an inch away. The Sensor itself may be located at a convenient place up

to the distance of the length of the wire included with the Sensor Extension.

DELETE OK

Edit Name

Sensor 1_

BACK SELECT

Sensor Extension

Extension

SENSOR ONLY