User's Manual Part 1

INSTALLING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[9]
Installing the Base
All LifeShield products work together as a system to protect your home. They must be installed in a specific order to work
properly. The Base must be installed first followed by the Handset, Console and Grid Extender.
Base Kit Components
BSC1000 Base
PSC0101 Power Adapter
LS180 Ni-MH Rechargeable Battery Pack
Phone Cord
Internet Cable
Install the Base
(Only 1 Base may be used on a system)
Install Battery Pack
Locate the LifeShield LS180 Rechargeable
Battery Pack.
a) Locate the Battery Pack.
b) Remove the battery compartment door.
c) Plug the 2-wire battery pack cord into the
plug receptacle and insert the battery into the
battery compartment.
d) Snap on the battery compartment door.
LEDs on the front of the Base
will illuminate briefly when
Battery Pack is first connected.
i
Connect Power Adapter
• Do not use an electrical outlet that is controlled by a switch.
• Insert the power adapter plug into the jack on the back of the
Base. Plug the power adapter into the wall outlet.
RISK OF EXPLOSION IF
BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING
TO THE INSTRUCTIONS.
!