User's Manual

Base
Phone
Cord
Ethernet
Cable
Phone
Cord
Phone
Wall Jack
Ethernet
Cable
Note:
1. If you are installing a router for the first
time, refer to your router installation
instructions for connecting.
2. InGrid recommends connecting the
phone line to all kit devices.
3. In many cases DSL modem
subscribers are required to add a
DSL line filter on their phones.
Contact your DSL service provider
for the filters and installation
instructions.
Resetting Your System
When a Base is replaced, every Handset,
Console and Grid Extender needs to be
reset to factory default settings and re-
registered to the system.
In addition, all sensors will need to be reset
to their factory default settings and re-
registered to the system.
Users will need to be re-established with
user codes.
Key Chain Remotes will need to be
reassigned to users.
Any settings that were customized during
the initial installation will need to be
reconfigured.
Master Code
Use the default code “1234” for entering the
Security menu to add your Grid Controllers,
Sensors and Key Chain Remotes or to add
users.
Return each Grid Controller to factory
default settings
Handset:
o Disconnect and reconnect the
battery
o Within 5 seconds of replacing the
battery, Press the * and # keys at
the same time
Display should show “not registered”
o Return the Handset to the Charger
Console:
o Remove the power supply from the
wall outlet
o Disconnect and reconnect the
battery
o Within 5 seconds of replacing the
battery, Press the * and # keys at
the same time
o Plug the power supply back into the
wall outlet
Display should show “not registered”
Grid Extender:
o If plugged into the phone line,
disconnect the telephone cable
o Remove the Grid Extender from the
wall outlet (if removing the outlet
screw, first turn the power off at the
circuit breaker box).
o Disconnect the battery
o
Do not plug the Grid Extender into
the outlet at this time
Place the Base in Registration Mode
After the Base is installed, press and hold
the Page button until the Base beeps twice
and the green light blinks continuously.
Re-register Your Components
Re-register Handsets and Consoles:
The Display should show “not registered”
o Press Menu and select
Setup/Security/Master Code/GC’s or
Handset/<Add New>
o Press Search
You will hear a beep and the display will
show “Handset” or “Console” Added
You will then be given the option to edit the
GC name