User Manual

Brinks Keypad 9
What to do:
1) To silence the Keypad’s beeping, press the CANCEL key.
2) Wait 30 minutes for the system to reset.
3) If the detector has not reset after 30 minutes, the trouble message returns and the Keypad beeps.
Component Failure
One of the system’s devices is not operating properly
Call Brink’s Indication
If you receive this trouble message, call Brink’s Customer Care at 1-800-445-0872 for assistance.
SPECIFICATIONS
Compatibility:........................................InGrid Grid Controllers, InGrid Wireless Sensors, Ademco Wireless Sensors
Wireless Range.................................................................................................................... 500 feet open-air (nominal)
Backup Battery Source:............................................................................................................ Use Only IG180 Battery
Storage Temperature: ............................................................................................... -30° F to 140° F (-34° C to 60° C)
Operating Temperature:.................................................................................................. 32° F to 120° F(0° C to 49° C)
Maximum Humidity: ......................................................................................... 90% relative humidity, noncondensing
Dimensions:.................................................................................6.5” (16.5 cm) W, 5.0” (12.7 cm) H, 1.4” (3.5 cm) D
US Patents 6,888,459 and others pending
Note: The Keypad contains a backup battery. The battery must be replaced within 7 days when a low battery
condition occurs to ensure that system events can be reported in the event of a power outage. Replace only with an
InGrid IG180 battery. There is a risk of explosion if an incorrect type of battery is installed.
NOTICES
FCC Part 15 Information
Changes or modifications not expressly approved by InGrid, Inc. can void the user’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference
in a residential installation.
FCC RF Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the equipment or the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the affected equipment and the panel receiver to separate outlets, on different branch circuits.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15 ID No. S9PBK410
Declaration of Conformity (DoC)
InGrid, Inc. declares that the model no. BK410 is in conformity with Part 15 of the FCC Rules. Operation of this
product is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.