User Manual

6 Brinks Keypad
How to View Alarm Memory
You can use alarm memory to determine which zones were in alarm.
1) Press the OPTIONS key until the message window displays: ALARM MEMORY, ENTER CODE.
2) Enter your user code. The Keypad beeps. The message window shows which zones were in alarm.
How to Delete an Auxiliary Code
If you wish to delete an auxiliary user code, do the following:
1) Press the OPTIONS key until the message window displays: AUXILIARY CODES, ENTER MASTER CODE.
2) Enter the master user code. The Keypad beeps. The message window displays: ENTER USER #.
3) Enter the number of the user whose code you wish to delete. The Keypad beeps. The window displays: ENTER
NEW CODE.
4) Do not enter the user’s code. Instead, press the CANCEL key. The Keypad beeps.
5) Test that the code has been deleted by attempting to turn the system on and off, using the deleted code.
¾ System Testing
You can test the components of the system—the sirens, the telephone hookup, and the Sensors—without causing a
false alarm. This section describes how you can be sure that the system is functioning properly.
Siren and Transmission Test
This test helps to ensure that the system’s siren is working properly, and that the system is able to send an alarm
signal to the Brink’s Monitoring Center. You will not receive a call from Brink’s. To test the system’s siren and
transmission, do the following:
1) Press the OPTIONS key until the message window displays: TEST, ENTER CODE.
2) Enter your code. The message window displays: TEST. A test signal is sent to Brink’s. If it is received, the
Keypad siren sounds briefly.
3) If you do not hear the beep or blast, and the Keypad message window displays CP TROUBLE, the test failed.
Testing All Sensors
This test helps to ensure that the system’s burglary Sensors are working properly. No alarm signal is sent to the
Brink’s Monitoring Center.
1) Make sure there is nothing moving near the motion detector and that the message window displays READY.
2) Press the OPTIONS key until the message window displays DOOR CHIME.
3) Press 2, 4. Then, press and hold the 7 key for three seconds.* The message window displays READY DOOR
CHIME TEST.
4) Open each protected door and window. Listen for the Keypad to sound the alarm. Close the door or window.
5) Walk in front of the motion detector (if any). The siren blasts each time the motion detector detects your
movements.
6) If you do not hear the siren blast, call Brink’s at 1-800-445-0872.
7) When you have finished, press the CANCEL key.
*Note: If the system has four-digit codes, press 2,4,7, then press and hold the 0 key for three seconds.
Testing the Doors and Windows Only
This test identifies whether the Sensors on your home’s protected doors and windows are operating properly. You
may prefer to conduct this test if you find it distracting to hear the siren blast each time you pass the motion detector
during the test. No alarm signals are sent to the Brink’s Monitoring Center. To test the system’s door and window
Sensors, follow the instructions on the next page. NOTE: If the system’s chime feature is on, skip steps 2 and 3 of
the Keypad instructions. When the chime feature is on, the Keypad beeps if configured to do so and the Signal
Extender can beep if configured when prompted using the door chime feature if a protected door or window is
opened while the system is off.
1) Close all doors and windows. Make sure the message window displays READY.
2) Press the OPTIONS key until the message window displays: DOOR CHIME.