User Manual

4 Brinks Keypad
Turning the System On with Motions Turned Off / Instant Mode
1) Close all of the doors and windows and make sure that the message window displays READY.
2) Press the ON key.
3) Press the MOTION OFF key.
4) Press the INSTANT key. The ON light turns on. The Keypad displays ON, MOTION OFF, and INSTANT.
Do not leave the building or open any protected windows without first turning the system off.
Turning the System On in Instant Mode
1) Close all of the doors and windows and make sure that the message window displays READY.
2) Press the ON key.
3) Press the INSTANT key. The ON light turns on. The Keypad displays ALL ON, INSTANT.
Do not leave the building open any protected windows, or move in front of the motion detector without first
turning the system off.
Turning the System On When It Is Not Ready
If the system is not ready to turn on, the message window of your Keypad displays NOT READY. This message
could mean, for example, that one of the protected windows in your house is open. If you press the ON key when the
system is not ready to turn on, the Keypad sounds an error tone and the system does not turn on. To make the system
ready to arm and to turn it on, do the following:
1) Observe the number displayed in the message window. This is the zone that needs to be corrected before the
system will turn on. (There may be more than one, if so, the numbers are shown one at a time.)
2) Refer to the Pop Up Grid Identification Card to verify the zone’s location.
3) If the zone is a door or window, make sure that it is securely closed.
4) If the message window displays READY, turn the system on.
5) If the message window displays NOT READY, see the Frequently Asked Questions information.
6) To turn the system on, you must first turn off the zone that is not ready to arm. Press the OPTIONS key until the
message window displays: BYPASS, ENTER ZONE #.
7) Enter the number of the not-ready zone, the same number that appeared in the message window. CAUTION: If
you bypass a zone, it will not be protected. The Keypad beeps. The message window displays READY,
BYPASS and the number of the bypassed zone is momentarily displayed.
8) Turn the system on.
¾ Turning the System Off
Turning the System Off When No Alarms Are In Progress
1) Enter through a designated entry door. The Keypad sounds a tone to remind you to turn the system off. The ON
light blinks.
2) Turn the system off by entering your code. To prevent an alarm, you must enter your code before the entry
delay ends. The standard delay is 40 seconds. Once the system is off, the ON light goes out.
Turning the System Off and Canceling an Alarm
Follow these instructions if you caused an alarm accidentally.
1) Enter through a designated entry door. The siren is sounding and the ON light blinks. The Keypad’s message
window displays ALARM.
2) Enter your user code. The Keypad beeps. The Keypad’s message window displays ALARM MEMORY.
3) Press the CANCEL key. (You must press the CANCEL key within 20 seconds of entering your code.) The
Keypad beeps. You will not receive a call from Brink’s. The Keypad’s message window displays ALARM
CANCELED.
Note: If you press the CANCEL key before entering your code, the result is the same.
Turning the System Off Without Canceling an Alarm
Follow these instructions if you wish to turn off the system and report an alarm to Brink’s.