Installation Guide

DONT’S
1. DO NOT use a tapping block or other tapping tools to install
this floor. Tapping this product will damage it. Use of a block is
allowed only when installing modified planks as described in step
#10 of the Installation Preparation section of this guide.
2. DO NOT use excessive force to connect planks together. If planks
are not connecting easily, check for damage or debris in the
locking mechanism.
3. DO NOT glue, nail or attach flooring in any way to your subfloor.
4. DO NOT use excessive liquid when cleaning.
5. DO NOT use abrasive cleaning solutions, lacquers, polishes, waxes
or detergent based cleaners.
DO’S
1. DO install cabinets and kitchen islands before installing floor.
2. DO acclimate unopened boxes of flooring for 12 hours before
installation if it was stored in temperatures outside of the
stated range (50 °F - 100 °F).
3. DO install in climate-controlled environment -
min. 50 °F (10 °C); Min. RH: 40-60%.
4. DO leave a 1/2 in (12.7 mm) expansion space around
entire perimeter of installation and any vertical objects.
Use spacers to assist.
5. DO inspect every plank for damage before installing it.
6. DO remove spills immediately.
HYBRID RESILIENT
PLANK FLOORING
DO’S AND DONT’S
REQUIRED TOOLS AND SUPPLIES