Installation Guide

• Install tiles in the center, one grid at a time. Finish each grid
before moving to the next. Start with the first tile in the corner
of the grid and work outward. Set tiles one at a time using a
slight twisting motion. NOTE: Don’t slide tiles into place.
• Insert tile spacers, as each tile is set, or leave equal joints
between tiles.
• Fit perimeter tiles in each grid last, leaving 1/4 in. gap
between tile and wall.
• When finished, tap in all tiles with a rubber mallet or hammer
and wood block, to ensure a good bond and level plane.
• Remove excess adhesive from joints with a putty knife, and
from tile with a damp sponge.
• Do not walk on tiles until they are set (usually in 24 hours).
5
WOOD-LOOK TILE INSTALLATION INSTRUCTIONS PAGE 3 of 4
• Using the instructions on the package, make enough grout to
use in about 30 minutes.
• Remove tile spacers and spread grout on the tile surface,
forcing down into joints with a rubber grout float or squeegee.
• Tilt the float at a 45° angle and remove excess grout from
surface immediately with the edge of float.
• Tilt it at a 90° angle and scrape it diagonally across tiles.
• Wait 15–20 minutes for grout to set slightly, then use a damp
sponge to clean grout residue from surface and smooth the
grout joints, rinsing sponge often.
• Let dry until grout is hard and haze forms on tile surface, then
polish with a soft cloth and wait 72 hours for heavy use.
6
Continued on next page
STEP 6:
GROUTING JOINTS
STEP 5:
SETTING TILE
Lifeproof Shadow Wood 6 in. x 24 in.
tile shown. (SKU 1002977061)
WOODLOOK TILE
INSTALLATION
Continued on next page