Installation Guide

CAUTION: ASBESTOS IN EXISTING FLOOR: Lifeproof product does not contain asbestos. Existing installed resilient flooring and
asphaltic adhesive may contain asbestos fillers or crystalline silica. Do not sand, dry sweep, dry scrape, drill, saw, bead-blast, or
mechanically chip or pulverize existing resilient flooring, backing, lining felt, asphaltic “cutback” adhesive or other adhesive. See
“Recommended Work Practices for Removal of Resilient Floor Coverings” (rfci.com) for detailedinformation and instructions on r
emoving all resilient covering structures.
Safety and Health Precautions
Warranty
Product Description
Pre-Installation
Power tools can be dangerous. Operate in strict accordance to manufacturer’s operating instructions and safety precautions. Unsafe and
improper use can cause serious injuries. Avoid inhalation and exposures to dust by mechanical means and by wearing personal
protective equipment. Wear appropriate personal protective equipment (PPE) which includes NIOSH or OSHA-approved dust masks,
safety goggles and work gloves.
OWNER/INSTALLER RESPONSIBILITY
The owner is advised to be at home during the installation for
consultation/direction. The owner and installer should discuss
installation and layout to maximize satisfaction. If this is not
possible, consultation should be done prior to installation.
Installers should be familiar with installation guidelines from
National Wood Flooring Association (woodfloors.org). The
owner/installer assumes all responsibility for product quality of
completed installation.
PERFORM PRE-INSTALL INSPECTION. OPEN UP TO 4 BOXES
PRIOR TO INSTALLATION AND EXAMINE COLOR, FINISH AND
QUALITY OF EACH PLANK CAREFULLY. IF YOU ARE
DISSATISFIED WITH THE MATERIAL, YOU SHOULD CONTACT
THE RETAILER PRIOR TO INSTALLATION. INSTALLATION OF
THE FLOOR INDICATES THE OWNER’S ACCEPTANCE OF THE
QUALITY OF THE PRODUCT.
Prior to installation, arrange planks from several boxes to ensure
even distribution of colors, shades and characteristics in the
installed flooring.
Purchase flooring to be installed in one large area at the same
time. Product purchased at a later time than the first purchase
may vary beyond your expectations.
Accessories, trims and moldings are manufactured to
The procedures and illustrations in this manual apply to plank, square tile and rectangular tile floorings.
This flooring product comes with a manufacturer Lifetime Limited Residential Warranty and 10 Years Light Commercial Warranty. For the
warranty to be effective, the flooring must be installed and maintained according to manufacturer’s installation instructions and
maintenance guide. The warranty applies to the original purchaser of the flooring for the duration of the stated warranty from date of
purchase. It guarantees the original purchaser that (1) the finish surface will not wear through from normal foot traffic, and (2) the floor will
resist damage due to moisture from general cleaning and water spills when removed within 24 hours or reasonable amount of time. The
warranty excludes damages resulting from outside the normal conditions including but not limited to: Scratches and dents from sharp
objects, shoes with spikes and cleats, environmental conditions including excessive humidity or extreme temperatures, mold/ mildew,
appliance leaks, natural disasters, Acts of God and damages which are generally covered by casualty insurance. For more detailed
warranty terms, coverage and exclusions, please visit homedepot.com/lifeproof.
Square TilePlank Rectangular Tile
Homedepot.com/lifeproof
Please contact 1-877-630-1800 for further assistance
THD-LP-VSPC-003 Print v3
.
coordinate with the varied appearances of the floor planks. Any
exact matches are coincidental. Non-matching accessories are
not defective products.
This product is manufactured according to strict quality
standards. In the event that defects are discovered in the field,
the industry standards permit a defect tolerance not to exceed
5%. Order an additional 5% extra for cutting wastage and
grading allowances (10% for diagonal installations). During
installation, inspect the planks continuously. Defects that can be
seen from a standing position should be cut off or held out.
Installing defective planks implies acceptance.
Squeaking and clicking noises are the result of interactions
among flooring, joists and subfloors when they move. Limiting
the movements of the flooring system usually eliminates most
of these noises. Sometimes, it is impossible to eliminate them
completely and minor squeaking or clicking noises are to be
accepted as normal flooring phenomenon.
Minor scratches can generally be repaired with the use of putty,
stain or filler. It is an industry standard practice of flooring
installation and it should be accepted as normal by the home
owner.
To assure the warranty is not inadvertently voided, before
proceeding with any activity that is not covered in this manual,
please contact our Customer Support Team at 877-630-1800.
Product Description Grade Levels
Installation Method
Vinyl SPC Flooring with click, fold,
and squeeze locking system.
Above Grade / On Grade
Below Grade
Floating.
Indoor use only.
RIGID CORE LUXURY VINYL PLANK FLOORING
PLANK AND TILE INSTALLATION INSTRUCTIONS