Use and Care Manual

MAINTENANCE
PUSH
1. Turn off the power switch in the rear of the unit.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You
may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to
clean the heater. This may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
7. Air filter needs cleaning after used 3 months of use. Please take off the filter with the 2
steps in the drawing below. Flush and clean the filter with water, Then, dry it out and
re-assemble.
[e-mail] [e-mail]
- 11 - - 12 -
4. Setting electro lock
The Electro Lock can help avoid the heater from being accidentally engaged by children.
The locking mechanism can be set in both the ON and OFF modes.
* If you do not use the heater for a long time, please take out the remote batteries (to
prevent corrosion ) as shown below. Store the remote in a safe place.
The Unit Remove Air Filter
Remove Bracket Screws (4X)
Lid
Battery
Press Temp Up and Temp Down buttons at the same time for 3
seconds. Locking is complete when you hear a beep. When locked,
the functions of the control panel and remote will be locked for use.
When you need to unlock it, press Temp Up and Temp Down buttons
at the same time for 3 seconds. You will hear a beep .The control
panel and remote control will become functional again.
or
and