Use and Care Manual

[e-mail] [e-mail]
1. Remote Control
Press the MODE button to toggle between the three heat modes.
2. Control Panel
High Mode uses 1500W; Low Mode uses 750W. ECO mode is an
Economic Energy Saving Function. When ECO mode is chosen, the
heater will manage itself from less to more heating power (watts) in
an attempt to maintain a constant warm 68℉(20℃)
Adjust the desired temperature by pressing the Up/Down arrows on
the control panel or remote control.
Desired temperature options vary from 59℉ to 86℉, or from 15℃ to
30℃. Once you have chosen the desired temperature, the heater will
remain on until the room temperature increases to the temperature
on the digital display. The heater will cycle on and off to maintain the
desired room temperature.
- 9 - - 10 -
Press ℃/℉ button to change the display temperature between
Fahrenheit and Celsius.
The Fahrenheit indicator LED will light , when the temperature is
displayed in Fahrenheit.）
The Celsius LED will light, when the temperature is displayed in
Celsius.
OPERATING INSTRUCTION
1. Plug in the power cord and power on button
2. Select working mode and setting desired temperature
Control
Panel
Remote
Control
Open the power
1. When you want to use the heater, please press power button "I" first.
2. When do not use it, please press power button " O " first.
Turn the heater on by pressing the ON/OFF button on the control panel
or by pressing the Power button on the supplied remote control.
Once power is off, heating element will stop working at first. Fan will
prolong working for 3 min to emit plenty of heat inside. This mark will
indicate running during the 3 min.
l
0
3. Setting the POWER OFF/ON TIMER Function
Note: (1). The Power-Off-Timer Function will allow for the heater to power OFF after a
certain set time, and can only be set while the heater display is in the “On” position
(2). The Power-ON-Timer Function will allow for the heater to power ON after a certain
set time, and can only be set while the heater display is in the “Off” position.
1. Turn the heater to the “On” position .Press the Timer button on
the heater’s control panel or the remote.
2. Turn the heater to the “OFF” position .Press the Timer button on
the heater’s control panel or the remote.
The digital display changes from the "temperature" to the "hours"
option for the timer. Continue to press the timer button to change the
number of hours you would like the heater to run before powering
itself off .The hour options for the timer are from 0 to 12 hrs.
(in 1 hr increments).
The selected hour increments will flash for a few seconds, then
revert back to the set desired temperature .The Timer indicator light
will remain lit as long as the Timer is set. The heater will power OFF
when the internal heater clock counts down the hour increments you
set.
or
or
or
or
or
or
or