Use and Care Manual
CONTROL PANEL
1. Signal receiving window: For receiving remote control signal.
2. Digital display: Indicate set room temperature or time
3. Power indicator light: Indicators that the heater is receiving power from outlet.
Will flash when powered "ON"
4. ON/OFF button: Powers the display on and off.
5. Energy-saving mode indicator: Will be lit when energy-saving mode is engaged.
6. Mode button: To select between High, Low and Eco modes.
7. Low Mode indicator light: Will be lit when Low Heat mode is engaged.
8.Temp up button: To increase desired temperature.
9. High Mode indicator light: Will be lit when High Heat mode is engaged.
10.Temp down button: To decrease desired temperature.
11. Timer indication light: Will be lit when the Timer mode is engaged.
12. Timer button: Used to engage timer mode and to set hour value for the timer.
13. Fahrenheit indicator light: Will be lit when temperature displayed is in Fahrenheit.
14. ℃/℉ Button: Alternates between Fahrenheit and Celsius.
15. Celsius indicator light: Will be lit when temperature displayed is in Celsius.
service@lifepluspro.com service@lifepluspro.com
- 7 - - 8 -
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet.
and turn on the power switch in the rear of the unit. Only operate heater in upright position.
Insert 2 AAA batteries into the remote control before using (Batteries Not Included).
At first startup, there may be a strange smell, which is caused by the evaporation of the
coating used to protect the metal inside the product. It is a non-toxic gas that will dissipate
after running for a period of time. If you cannot accept this odor, you can use it outside the
door for 15 minutes before entering the house.
REMOTE CONTROL
ON/OFF Button:
Used for power-on or power-off
Temp Down Button:
To make set temperature decline
Mode Button:
Used for mode selection
Timer Button:
Used for setting timer and adjust time value of timing
℃/℉ Button:
Button for alternating between Fahrenheit and Celsius
Temp Up Button:
To make set temperature rise
1
1
6
12 11
2
2
14
15
13
3
3
4
4
10
9
8 7
6
5
5
1
2
3
4
5
6