INFRARED QUARTZ HEATER MODEL #LS-8WIQH-LB /DB lifelux® is a registered trademark of lifecorp products, All Rights Reserved. ATTACH YOUR RECEIPT HERE Purchase Date ____________Serial Number (located on back of unit) __________________ Questions, problems, missing parts? Contact technical support department at 1-866-484-2066, 8:00 a.m. - 5 p.m., CST, Monday - Friday or www.@lifecorpproducts.com Please have your model and serial number ready.
TABLE OF CONTENTS Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Frequently Asked Questions . . . . . . . . . . . . . . . . . . . .
PACKAGE CONTENTS A D C E F G Front View Rear View B PART DESCRIPTION QUANTITY A B C Infrared Heater Remote Control Control Panel (preassembled to Infrared Heater (A)) Master Power Switch (preassembled to Infrared Heater (A)) Filter Cover (preassembled to Infrared Heater (A)) Temperature Sensor (preassembled to Infrared Heater (A)) Caster Wheels (preassembled to Infrared Heater (A)) 1 1 1 D E F F 3 1 1 1 4
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product. IMPORTANT SAFETY INSTRUCTIONS WARNING: POTENTIAL ELECTRICAL HAZARD IF NOT ADHERED TO. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • This heater must be plugged into a 120 V, 15 amp (or more) circuit of its own.
SAFETY INFORMATION Tip-Over Safety Feature This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To continue operation, turn on the heater using the supplied remote control or the control panel on the heater. Overheat Safety Feature This heater is equipped with an overheat safety feature.
FREQUENTLY ASKED QUESTIONS Please review these frequently asked questions on the next few pages prior to using your heater. Q. My heater emits a strange odor when I first open the box and when I turn the heater on for the first time. Why is this happening? A. This is normal. This heater is treated with a special heat safe/resistant coating. This odor will sometimes be present when the box is opened.
FREQUENTLY ASKED QUESTIONS Q. The temperature on my heater does not match the temperature display on my wall, or external thermostat. Why? A. This is completely normal. The temperature display on your heater may vary from the temperature display on another thermostat (like the one mounted to your wall or a purchased external thermostat). This is because the temperature sensor on the heater reads the temperature directly around the heater.
PREPERATION Place the heater on a firm, level surface and plug into a grounded 120 V, 60 Hz power outlet and turn on the power switch on the rear of the unit. Only operate heater in upright position. Insert two AAA batteries into the remote control before using (batteries not included). Please note that infrared heaters do not heat like a traditional space heater. You should not expect infrared heaters to blow hot air like a traditional space heater. Infrared heaters heat objects not air.
CONTROL PANEL 1 2 3 4 5 16 15 High Low Eco 6 14 13 PART 12 11 10 NAME 9 8 7 DESCRIPTION 1 Ionizer Indicator Light Indicates when the ionizer function is active 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Timer Indicator Light Digital Display Celsius Indicator Light Fahrenheit Indicator Light Power Indicator Light Power Switch Button C/F Button Temp-Down Button Temp-Up Button Timer Button Heater Mode Button Ionizer Button Energy Saving Indicator High Heat indicator Low Heat Indicator Indicat
REMOTE CONTROL 1 5 2 6 3 7 PART 1 2 3 4 5 6 7 4 NAME LED Indicator Light Heat Button Temp Down Button ON/OFF Button Temp Up Button Timer Button Ionizer Button DESCRIPTION Illuminates when any button is pressed on the remote control Toggles between the three heat modes available Decreases the set temperature value Powers the heater on or off Increases the set temperature value Engaes the on/off timer Engages the ionizer on/off 10
OPERATING INSTRUCTIONS 1. Turn the heater on or off by pressing the Power button on the control panel (C) or by pressing the ON/OFF button on the remote control (B). 1 Once the power is off, heating elements will stop working first. The fan will continue working for up to 90 seconds to dispense residual heat inside the heater. This is a normal function. 2.
CARE AND MAINTENANCE WARNING: Before performing any maintenance task, turn off the power switch in the rear of the unit, unplug the unit, and allow it to cool completely. 1. To keep the heater clean, clean the outer shell with a soft, damp cloth. Use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 2. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater.
ONE-YEAR LIMITED WARRANTY The manufacturer warrants this heater against defects in materials and workmanship on functional parts, for a period of 1 year from the original date of purchase. Your sales receipt showing the date of purchase of the product is your proof of purchase. Keep it in a safe place for future reference. This product is made with the highest quality materials and is warranted to be free from defects in materials and workmanship at the time of purchase.
REPLACEMENT PARTS LIST For replacement parts, call our technical support department at 1-866-484-2066, 8 a.m. - 5 p.m., CST, Monday - Friday or Warranty@lifecorpproducts.
