Use Instructions
15
Questions? Call 1-800-635-6156
Signal Coverage
Please see the Quick Setup Guide located in the box for
instructions on how to set up your GoSafe 2 system. Your
Pendant must be tested prior to use by initiating a call to
the Response Center. The GoSafe 2 Mobile Pendant is a
radio frequency (RF) device that transmits a signal to the
Lifeline Response Center over a wireless network. It relies
upon adequate network signal strength and availability to
send your help signal to the Lifeline Response Center. Signal
strength and availability inside of your home is tested during
the system setup process, but can vary from time to time
depending on multiple factors. It is therefore recommended
that, once your welcome/setup call is complete, you go to
areas of your home where you commonly spend time, as
well as areas where you are most likely to have an accident –
such as the bedroom, bathroom and kitchen – to check that
your GoSafe 2 Pendant has sucient cellular signal available
to operate reliably from within your home. See the caution
section on page 17.
Caution: Your GoSafe 2 Pendant is designed to work
inside and outside of your home from anywhere sucient
connectivity to the AT&T cellular network is available. When
you press the Help Button while away from home, help will
be sent to your location.* Please refer to page 25 for further
information.
It is important to note that the ability of your GoSafe 2
Mobile Pendant to make a help call may be aected by
environmental factors, including certain materials & methods
MHB3_7250_IFU 2020c.indd 15 2/15/21 2:28 PM