Use Instructions
76
Questions? Call 1-800-635-6156
ACTA (Administration Council for Terminal Attachments) Information
The 7000L Communicator complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. On the bottom of the Communicator is a label that contains,
among other information, a product identier in the format US:AAAEQ##TXXXX. If
requested, this number must be provided to the telephone company.
A plug and jack used to connect this equipment to the premises’ wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements adopted
by the ACTA. A compliant telephone cord and modular plug is provided with this
product. It is designed to be connected to a compatible modular jack that is also
compliant. See installation instructions for details.
If your home has specially wired alarm equipment connected to the telephone line,
ensure that the installation of the 7000L Communicator does not disable your alarm
equipment. If you have questions about what will disable alarm equipment, consult
your telephone company or a qualied installer.
Caution
In order for “alarm dialing equipment” to be able to seize the phone line to report an
alarm or other event when other equipment (telephone, answering system, computer
modem, etc.) is connected to the same line is in use, “alarm dialing equipment” must
be connected to a properly installed RJ31X jack. The RJ31X jack must be connected in
series with, and ahead of, all other equipment attached to the same phone line. Series
installation of an RJ31X jack is depicted in the gure shown on page 44. If you have any
questions concerning these instructions, you should consult your telephone company
or a qualied installer about installing the necessary jack and alarm dialing equipment
for you. If you choose to install your system utilizing the RJ31X conguration, please
contact Philips Lifeline to obtain a phone cord for your home communicator that
supports RJ31X function.
Industry Canada Notice to Users
The HomeSafe/GoSafe devices comply with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
1) Device may not cause interference
2) Device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
1) l’appareil ne doit pas produire de brouillage
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
Agency Submission File