Use Instructions

59
Questions? Call 1-800-635-6156
When the device detects a Medium priority alarm: The
Message button on the Communicator ashes yellow/orange.
The operator must press the Message button to hear a
recorded voice message describing the alarm condition and/or
what to do about the alarm condition.
Silencing Alarms
Once a High Priority alarm is detected, it cannot be silenced.
Lowering the volume slider on the Communicator will lower
the volume of the voice prompts played, but the alarm
messages will still play.
Medium Priority alarms are silent until the User presses the
Message button to hear what the alarm condition is and how
to act upon it. The recorded voice messages will continue to
play each time the Message button is pressed, until the alarm
condition is corrected.
Resetting an Alarm
High priority alarms are normally reset by the Response
Center after the alarm has been responded to. Additionally,
the Communicator may periodically poll the Response Center
to see if the alarm should be reset and does so accordingly.
Note: Turning the Communicator OFF during the reporting
of a high priority alarm will reset the device, but since the
alarm has already been reported to the Response Center, the
Response Center will likely attempt to contact the Subscriber.
If an alarm is accidentally initiated by the User, they should not
turn o the Communicator. Instead, they should wait for the
Response Center to establish voice communication and simply
state that the alarm was sent accidentally.
Agency Submission File