Use Instructions

Questions? Call 1-800-635-6156

them all for this process. You will need to reprogram all of

them, even if you are only replacing one of them. Be sure to

set aside the Help Button that is being replaced (your old

button) to avoid confusing new and old Help Buttons.

1. Make sure that your Communicator

is powered ON and that you have

your replacement Help Button

in hand.

2. PRESS and HOLD DOWN

the Message button on the

Communicator. The Communicator

will beep and announce: “Continue to hold the Message

button for AutoLearn. When you are ready for Range Test,

please release the Message button.”

Do not release the Message button until you get to Step 4.

3. Continue to hold down the Message button on your

Communicator. With your other hand, press the wearable

Help Button. You will hear a long beep and a voice message

saying: “Your Lifeline Help Button is now auto-learned

and ready to use.” The Communicator will also announce

the four large digits that appear on the back of your Help

Button. This will indicate that the Help Button is working

with the Communicator. If the AutoLearn process fails,

please contact Philips Lifeline or your representative.

4. Repeat step 3 to reprogram all the other Help Buttons

in your home. Then, release the Message button on the

Communicator. The Communicator will announce: “Please

press the ashing Message button after you have completed

the range test. Begin Signal Range Test.” (see p. 11)

Agency Submission File