Use Instructions

17
Questions? Call 1-800-635-6156
3. Reconnect the power cord to the power outlet. If you have
the Landline Communicator, reconnect the telephone cord
to the wall jack, and then move the power switch on the
back of the Communicator to the ON position.
4. Test your system by pressing your Help Button. Tell
the Response Associate that you are just testing your
equipment after cleaning it and that no help is needed.
Caution
Never allow water or other liquids to enter the product, since
these may cause electrical short-circuits or metal corrosion.
Do not spray water or cleaners directly on your Communicator.
Excessive moisture could get inside the Communicator and
cause damage.
Backup battery
Your Communicator uses a factory-installed battery back
up. If you lose power, the backup battery begins to work
automatically*. The Communicator will send a silent signal to
Lifeline to indicate that the Communicator is using its backup
battery. The backup battery can last for up to 30 hours,
depending on the battery age, charge condition at point of
ac power loss and environmental conditions.
If your Communicator battery needs to be replaced, a
silent signal will be sent to Lifeline, and Lifeline or your
representative will contact you to arrange for a replacement.
* For 7000L Communicators, if the land line phone service is interrupted by the power
outage, the Communicator will not be able to send any signals to Lifeline until
power is restored. For 7200C, to conserve power, the Signal Strength Indicator is not
illuminated when running on battery power to help prolong battery operation.
Agency Submission File