Use Instructions
12
Questions? Call 1-800-635-6156
Communicator and still call for help. If you press your Help
Button outside of your apartment, but still within the range
of the Communicator, help will be sent to the location of the
Communicator. Lifeline links your home address on-le in your
subscription to your Communicator equipment identication
number. Do not move your Communicator to a new address
without rst notifying Lifeline and providing the new address.
See page 14 for more information.
Note: If you have the GoSafe Mobile Button you can call for
help outside the range of your Communicator as well, when
the AT&T Wireless network is available. Help will be sent to
your location. Please refer to page 47 for further information.
GoSafe is the only one of these three buttons designed to
allow you to call for help when outside of the signal range of
the Communicator.
Signal Range Test
You should conduct a Signal Range Test during system
installation, and if you move your Communicator to a dierent
location in your home.
1. Make sure that your Communicator is powered ON and that
you have your Help Button in hand.
2. PRESS and HOLD DOWN the Message button on the
Communicator. The Communicator will beep and announce:
“Continue to hold the Message button for AutoLearn. When
you are ready for Range Test, please release the Message
button.”
Agency Submission File