User Manual

14
Questions? Call 1-800-635-6156
draft
Signal Range
Please see the Quick Setup Guide located in the box for
instructions on how to set up your GoSafe Lite system. and test
the range of your Help Button. The coverage area of the your
Help Button must be tested prior to use. The GoSafe Lite
pendant is a radio frequency (RF) device that transmits a signal
to the Lifeline call center over the Cellular network. It depends
upon cellular network availability to send your help signal to the
Lifeline call center. Signal availability inside of your home is
defined during the system setup process, but can vary from time
to time depending on multiple factors.
It is recommended that, once your welcome/setup call is
complete, you go to areas of your home where you commonly
spend time, as well as areas where you are most likely to have
an accident – such as the bathroom and kitchen – to help
ensure that your GoSafe Lite pendant has sufficient signal to
operate reliably.
Caution
[add note about cellular limitations indoors here], for example: The strength
of the wireless (cellular) signal, etc.... same as in page 16.
Note: Your GoSafe Lite pendant is designed to work inside and
outside of your home from anywhere sufficient connectivity to
the AT&T cellular network is available. When you activate your
pendant away from home, Help will be sent to your location.
Please refer to page 24 for further information.
It is important to note that the ability of your GoSafe Lite
Pendant to make a help call may be affected by enviro
nmental
factors, including building materials, large masses covering the
Help Button (i.e. a person laying on top of it) and submersion in
liquid.
Confidential Draft for Agency Submission Only.
Not for Posting on any Public-Facing Website
Not for dissemination to the public without the express written consent of Philips.