EMASCULATE VIO TV sandpiper NAEKTPIKGY GUIDEBOOK. CERENKOV LE TOV TOMTITS poppa oag via Th SIABECIPSTNTA Doug. H Un op Br) sandpit NAEKTPIKGY GUOKELGMV Unpeople va Spokane parvenu Tou pompous opiate kal enakcAoUBng POLTAVA TONY SPIKY Mississauga NPOKAADVTAG Patagonian ony eyelash cag. PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS.
7. £4 CAUTION: The fan must be grounded. 8. £4 CAUTION: Do not use the appliance before assembling it. 9. Make sure the power cord is properly grounded to avoid the risk of electric shock. 10. The fan must be installed in such a way that the blades are at a height of more than 2.3 meters from the floor. 11. During installation, make sure that there is a distance of at least 15cm. from the edge of the fins to the wall and from any other object.
children. 24. £\ CAUTION: To avoid injury, do not place or insert any object into the fan blades when the appliance is connected to the power supply or when it is in operation. Avoid contact with any moving part. 25. Before tuning on the fan, make sure all connections are stable and secure. 26. A WARNING: Due to the natural movement of the fan, some connections may loosen. Check support joints, brackets and blade fittings at least twice a year to make sure they are secure. 27.
REMOTE CONTROL 1. Medium air fan speed selection key 2. Low air fan speed selection key High air fan speed selection key Fan ON / OFF button =D 5. Lampshade ON / OFF button ? ‘ 6. Timer activation key (1 hour) Timer activation key (2 hours) 10 : 8. Timer activation key (4 hours) s 9. Timer activation key (8 hours) 10. Indicator light CEILING FAN INSTALLATION 1. Remove all packing materials and keep them away from babies and children. 2.
5. Then pass the motor power cords through the hole in the lampshade holding element. Install the lampshade holding element by aligning its holes with the corresponding holes in the motor body. Then insert the three screws into the respective holes and screw them in until they lock into place. 6. Place the LED bulb in the socket (max. 20W) and then place the lampshade cover on the lampshade holding element by muting it dock wise to lock it in place. 7.
9. Place the appliance on the ceiling mount. Install the mounting bracket to the mounting base and rotate the appliance until the side holes of the mounting bracket align with the holes in the mounting bracket. Then secure by tightening the 3 screws until the fan secures with the mounting base. 4 USE OF REMOTE CONTROL 1. Use the remote control to set the fan speed and switch the light and the fan on/off, and to set the desired operating time. 2.
3. Hold the lamp firmly and remove it by muting it counterclockwise. /\ CAUTION: The lamp may be very hot! Allow the bulb to cool enough before replacing. 4. Install the new bulb and rotate it dock wise until it locks into place. Use ONLY LED lamps, up to 20W each. 5. Place the lampshade on the luminary stand by muting it clockwise to lock it in place. 6. Connect the appliance to the power supply. CLEANING AND MAINTENANCE Follow the instructions to safely take care of the appliance. 1.
