PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS. Read the operating instructions carefully before putting the appliance into operation and keep the instructions, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions. USER MANUAL SYMBOLS Important information for your safety is specially marked.
should always tum the device off. 11. The protective grills are to prevent direct access to moving parts when the fan is in use Avoid contact with any moving parts. 12. To avoid injury, do not insert your fingers between the grilles when the appliance is plugged in or when it is turned on. 13. Do not move the fan while it is running. Disconnect the fan and wait until the fan blades stop completely. 14. Do not place clothes or other objects on the fan. 15. Do not use the appliance near curtains. 16.
2. Batteries can leak and lose battery acid. If the remote control is not used for a long period of time, remove the batteries. PARTS IDENTIFICATION 1. Front grille 2. Fan blades 3. Motor 4. Tilt angle adjustment 5. Support arm 6. Mounting base 7. Controller 8. Remote control REMOTE CONTROL 1. ON / OFF button 2. Natural wind mode selection button 3. Timer button 4. Oscillation button 5. Speed selection button CONTROLLER 1. Indicator lights (fan operating speed) 2.
supports. 3. Slide the support arm over the mounting base from the top and secure it with 2 fixing screws {Included In the package). 4. Unscrew the mounting screws located on the motor cover and insert the motor into the socket on the end of the mounting bracket. Then secure the motor to the mounting pace by attaching the mounting screws. /\ CAUTION: Make sure the motor is properly locked in place and there is no risk of it slipping out of use. 5. Loosen the 4 screws located on the front part of the motor.
previous timer setting will be lost. SELECTION OF FAN INCLINATION Follow these steps to select the desired tilt angle: Mounting bot Mounting screw 1. Remove the mounting bolt. 2. Loosen the mounting screw. 3. Select the desired angle of inclination of the fan and insert the mounting bolt. 4. Secure by tightening the mounting screw. AA CAUTION: Make sure It Is securely locked and firmly In place before operating the appliance.
