Getting Started Guide

CLASS 4
6
Introducing Blocks
The “waiting” block changes the progam by waiting by a certain number of seconds and makes it easier for
coding.
The “waiting” block pauses the program until it satisfies the specific condition
The “waiting” block in the figure above makes the program wait until an infrared sensor connects to Digital
INPUT Port 2 is pressed.
The “waiting” block from the figure above makes the program wait until the measurement of an infrared sensor
is connected to Analog INPUT Port 0 is less than 100.
Tip : You can also use the “repeating”
block with the function of the “waiting”
block. Think about how you can use
this!
introducing Waiting Block
위에 보이는 기다리기 블록은 디지털 INPUT 포트 2에 연결된 적외선 센서가 눌려 지
기 전까지 기다리게 해줘요.