Users Manual

SCRATCH CODING KIT

When using a wireless remote, there are few things you have to set up before using.

1) Setting the same channel as the main board and remote control

2) Connect REMOTE RECEIVER and the main board (wireless remote control and REMOTE RECEIVER can

exchange signal and control motion)

3) Set main board to ‘F’ mode.

1. Switch 1 is turned off

2. Turn on switch 1 while pressing switch 2

3. Segment window shows the currently saved channel

4. Change channel by pressing switch 2 again.

5. Move to desired channel and wait 2 seconds. IF

segment blinks 3 times, channel setting is completed.

① Power on/off

Segment window

② Mode setting switch

1. Switch 1 is turned off

2. Turn on switch 1 while pressing switch 2

3. Segment window shows the currently saved channel

4. Press switch 1 and 3 (top and bottom) to change

channel

5. Move to desired channel and press switch 4 to save.

How to set wireless remote control channel

How to set the main board channel

Wired/Wireless remote control

2. Using a wireless remote control