Installation Manual

2
3
4
1
Installing Sections: Start at a double hole (where sections connect) and put your rst pole in. You
should always lean the pole you are leading with back as shown below in Fig. 20 to get it started in the
hole. Then push the pole forward along the line of fence and down into the hole until the bottom of
the fence is flush with the deck sleeve. Repeat this until all of your full sections are installed.
Fig. 20
Measuring Your Custom Cut: Your custom section is the one that doesn’t t. The rst step is to measure
your custom cut. Note whether you will be cutting from the right side or the left side of the full section.
See Fig. 21 below.
LEFT SIDE
RIGHT SIDE
1
2
3
4
5
PRO NOTE: When measuring for a custom cut or cutting fence you should always remember that the
mold-ings face out away from the pool. When measuring your cut section, always face the pool.
Fig. 21
Step 4: Making Your Custom Cut
5
1
Custom
Cut
Screws face away
from the pool
This is the
panel where
the cut will be
Screws face away
from the pool