Installation Manual

Drilling: Begin at your start point to drill out fence as shown below in Fig. 18. Check the hole you are

about to drill making sure you have the appropriate degree of lean and the direction of the hole to be

drilled either towards the pool or away from the pool. In this example we are drilling away from the pool.

Remember to always adjust your bubble indicator to level.

Sleeving: Once drilling is completed, flush out the debris from the holes using a garden hose

Fig. 19. Next insert the plastic sleeves in the holes and tap down completely Fig. 20.

***NOTE: IF YOU ARE INSTALLING INTO ANY SURFACE BESIDES CONCRETE GO TO

WWW.POOLFENCEDIY.COM TO FIND THE INSTRUCTIONS FOR YOUR SURFACE

Fig. 19

Fig. 18

Fig. 20

Direction of Lean

NOTE: Stabilize drill guide with foot pressure to prevent

drill guide from shifting.

PRO NOTE: To keep from damaging the sleeve,

place a wood block on top of it as shown and

gently tap the sleeve down into the hole until

it is flush with the ground.

Light Lean