Installation Manual

2
4
1
5
1
3
Place the tape measure down and measure
odd panel
(NOTE: Make sure you are facing
the pool).
Fig. 23
Pole 1
5 1
2
3
4 5 1
Measure the outside centerline of the odd panel. Next, count the number of poles in the odd section
and double check whether it is a cut to the right or a cut to the left. See Fig. 22-23.
Fig. 22
5
If you notice in Fig. 22 our example custom cut is a 4 pole and then a cut to the right. Let's say this cut is a
4 pole 23 1/2" to the right. When you measure make sure you are measuring between the two centerlines
of either hole. Fig. 23 illustrates the scribe lines but, when you are ready to measure for your cut you will
be dealing with drilled holes in the concrete and there will be no scribe lines drawn across the holes. The
scribe lines in the gure are to remind you that if your cut happens to fall on a turn, you must remember
that your center line turns as well.
Make Your Cut: Now you have the measurement and you can make the cut. Roll out your full section
(screws facing up) in front of the custom cut area and face the pool. Looking at the full section count the
poles over until you reach the panel that needs to be cut. Our example cut is a 4 pole 23 1/2" to the right.
See Fig 24 below.
LEFT RIGHT
Pole1 Pole 2 Pole 3
4th pole
5
You will be cutting after
the 4th pole to the right
Fig. 24
Custom Cut
to the right
23 1/2”
0”
Pole 2
Pole 3
Pole 4
Right
Custom
Cut