Service Manual

Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes

How To... REPLACE THE SEAT PAD and HANDLEBAR ASSEMBLY

Tools Required: Allen wrench set, Torx wrench set, and torque wrench

1. Remove the four ALLEN SCREWS and

WASHERS securing the SEAT PAD to the

SEAT ASSEMBLY.

2. Remove the SEAT PAD from the SEAT

ASSEMBLY.

3. Replace the SEAT PAD and secure with

ALLEN SCREWS and WASHERS. Torque

ALLEN SCREWS to 55-60 IN. LBS.

4. Remove the four TORX SCREWS and

WASHERS securing the HANDLEBAR

ASSEMBLY to the SEAT ASSEMBLY.

5. Remove the HANDLEBAR ASSEMBLY.

Disconnect HR CABLE (LC9500HR ONLY)

6. Install new HANDLEBAR ASSEMBLY and

secure with TORX SCREWS and

WASHERS. Reconnect HR cable

(LC9500HR ONLY). Torque TORX SCREWS

to 32-34 IN. LBS.

7. Replace the SEAT PAD and secure with ALLEN SCREWS and WASHERS. Torque ALLEN SCREWS to 55-

60 IN. LBS.

Torx Screws

160-180 IN. LBS.

Washers

Seat Pad

Handlebar Assembly

Allen Screws(4)

55-60 IN. LBS.

Washer(4)

Seat Assembly

Heart Rate

Cable

Section III