Service Manual

24
Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To... REPLACE SIDE SHROUDS
Tools Required: 5/8 inch open-end wrench, standard screwdriver, torx wrench set
1. Remove the LEFT PEDAL in a
clockwise rotation.
2. Remove the 2 screws securing the
ENDCAP and remove.
3. Remove 7 screws from the RIGHT
SHROUD.
4. Remove the RIGHT SHROUD.
Position the right crankarm at the 2
o’clock position and guide the
SHROUD up and over the crankarm.
5. Inside the LEFT SHROUD, remove
the left shroud screw (see illustration)
from the center of the IDLER
BRACKET.
6. From the outside of the LEFT
SHROUD, remove 4 outer screws.
7. Position the left crankarm to a 10 o’clock position and carefully guide the LEFT SHROUD up and over the left
crankarm and pedal.
8. Replace the SHROUDS and ENDCAP in reverse order.
Left Shroud
Left Shroud Screw
(Inside Shroud)
Left Pedal
Right Shroud
End Cap
Torque Shroud Screws
6-10 IN. LBS.