Service Manual

18
Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To... REPLACE THE ALTERNATOR CONTROL BOARD
Tools Required: Standard screwdriver
1. Remove the right SHROUD. Refer to See
How To...Replace Shrouds” in this section.
2. Note the WIRE HARNESS position and
disconnect the ALTERNATOR (P2) and
MAIN WIRE HARNESSES (P1) from the
ALTERNATOR CONTROL BOARD.
3. Remove four mounting SCREWS securing
the ALTERNATOR CONTROL BOARD to its
mounting bracket.
4. Install new Alternator Control Board in
reverse order.
Alternator
Control
Board
Alternator Control Board
Mounting Bracket
Alternator Wire
Harness
Main Wire
Harness
Control Board
Mounting Screws(4)