Service Manual

8
Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To...REPLACE THE POWER GRIP BELT (Continued)
6. Remove the RETAINER BOLT and
RETAINER from the end of the
SHAFT.
7. Remove the left E-RING from the left
side of the PULLEY first, then remove
the right E-RING.
8. From the belt side, tap out the SHAFT
from the unit.
9. Pull the FREEWHEEL/PULLEY
ASSEMBLY forward and out of the bike
and remove the POWER GRIP BELT.
10. Install the new alternator in the reverse order. Make
sure that the ALTERNATOR BELT is properly aligned
to the LARGE PULLEY as shown otherwise damage to
the belt can occur.
11. Locate the alternator at the marked area on the
alternator bracket. Alternator belt tension should be
from 60-70 lbs. and the POWER GRIP BELT from 35-
55 lbs.
Large Pulley
Alternator Belt
A
lternator Pulle
y
Retainer Bolt
Retainer
Pulley Shaft
E-Ring
Washer
Washer
Pulley
Freewheel
Washer
E-Ring