User Manual

NOTICE
Risk of condensation damage for Side-by-Side appliances!*
Certain appliances can be set up as Side-by-Side combina-
tions (two appliances next to each other).
If your appliance is a Side-by-Side (SBS) appliance:
u
Set up the SBS combination in accordance with the
enclosed document.
If the positioning of the devices is stipulated:
u
Do not change the door hinges over.
4.3.1 Remove the soft stop mechanism
Fig. 9
u
Open the door.
NOTICE
Risk of damage!
If the door seal is damaged, the door may fail to close properly
and the cooling will be inadequate.
u
Do not damage the door seal with the screwdriver!
u
Remove the outer cover. Fig. 9 (1)
u
Disengage and release the bearing bracket cover. Remove
the bearing bracket cover. Fig. 9 (2)
u
Unlatch the panel with a slotted screwdriver and swivel it to
one side. Fig. 9 (3)
Fig. 10
CAUTION
Crushing hazard by joint folding up!
u
Engage safety device.
u
Engage the locking device in the opening.
Fig. 10 (1)
u
Unscrew the bolt with a screwdriver.
Fig. 10 (2)
u
Remove the bolt in an upward direction.
Fig. 10 (3)
u
Turn the hinge in the direction of the door.
Fig. 10 (4)
Fig. 11
u
Press the tab with the slotted screwdriver. Fig. 11 (1)
u
Pull cover out of the catch mechanism. Fig. 11 (2)
Fig. 12
u
Undo the soft stop mechanism screw with a T15 screwdriver
approx. 14 mm.
Fig. 12 (1)
u
Insert a screwdriver behind the soft stop mechanism on the
handle side and rotate forwards.
Fig. 12 (2)
u
Remove the soft stop mechanism.
Fig. 12 (3)
4.3.2 Remove the door
Note
u
Remove any food from the door racks before removing the
door, so that no food falls out.
Putting into operation
8 * Depending on model and options