Side by Side Installation MRB 2400 / MRB 3000 / MRB 3600 MF 1851 / MF 2451 7083 044-00
Parts list of SBS Installation Kit Image Article number Name of the item 6943 001-00 Heating blanket 9022 776-00 Front connecting plate 9022 778-00 Rear connecting plates 9022 777-00 Top connecting plate 2
Image Article number Name of the item 7641 033-00 Sealing strip 4098 066-01 Screws 6 x 25 4084 005-01 Screws M4 x 13 Other parts used in this installation manual are supplied with the appliance, not with the SBS Kit.
Side by Side (SBS) Installation 1. Remove the anti-tipping brackets from both appliances. The screws are no longer needed. WARNING! Risk of fire or damage. The accessory is intended for use only with an appliance that is marked to indicate such use. This kit may only be installed with models MRB 2400, MRB 3000, MRB 3600 MF 1850, MF 2450 The Side by Side installation should only be done by a trained expert. We recommend this procedure be done by two people. WARNING! Electrocution hazard.
2. Mark the recess centerline on the back wall. 3. Mark a centerline on the left and right between the recess centerline and the walls of the recess. 4. Position each anti-tipping bracket at the stated height and align with the centerline. 5. Fasten the anti-tipping bracket through the outer left and right and any other hole using the screws 6 x 60 provided with the appliance. Use appropriate anchors for concrete walls. 6. Loosen the protective foil of the heating blanket top.
8. Bend the lower tongue of the heating blanket around the corner and adhere to the back of the appliance. 9. Connect the cable of the heating blanket with the socket.
10. Move the right appliance in front of the recess and leave enough space to work behind. 11. Move the leftt appliance in front of the recess and leave a space of approx. 1/4" (6 mm) between the appliances. Remove the inner transit supports using a Torx 25 key.
12. Attach the top connecting plate and fasten with the screws M 4 x 13. Key Torx 25. 13. Attach the front connecting plate and fasten with the screws 6 x 25. Key Torx 25. 14. Attach the connecting plate at the top of the appliance rear and fasten with the screws 6 x 25. Key Torx 25. 15. Attach the connecting plate at the bottom of the appliance rear and fasten with the screws 6 x 25. Key Torx 25.
Torx 15 16. Apply the appliance cover strips to the left and right front edge of the appliance housing, align in height with the top profile and screw into place. The strip is transparent so the designed mounting holes on the appliance housing are visible. Cover strips and screws 3.5 x 13 are provided with the appliance. Complete the installation as described in chapter Appliance Installation in the installation instructions of the appliance. 17.
Notes 11
For Service in the U.S. Liebherr Service Center Toll Free: 1-866-LIEBHER or 1-866-543-2437 Email: Service-appliances.us@liebherr.com PlusOne Solutions, Inc. 3501 Quadrangle Blvd, Suite 120 Orlando, FL 32817 For Service in Canada Liebherr Service Center Toll Free: 1-888-LIEBHER or 1-888-543-2437 www.euro-parts.ca EURO-PARTS CANADA 39822 Belgrave Road Belgrave, Ontario, N0G 1E0 Phone: (519) 357-3320 Fax: (519) 357-1326 www.liebherr-appliances.
