Operating instructions

20
C leaning
• Dry all parts well with a cloth.
• Do not damage or remove the model plate on the
inside of the appliance. It is very important for servic-
ing your appliance.
• Install the drawers.
Place the drawer on
the rails. The rails
must be fully extend-
ed and aligned with
the front of the draw-
er. Slide the drawer in.
• Install all equipment parts and replace the food in the
appliance. Refer to chapter Equipment.
• Turn the appliance on.
Cleaning
WARNING!WARNING!
• To prevent possible injury due to an electric
shock, be sure to disconnect the power cord
or turn off the circuit breaker before cleaning
the appliance.
• To avoid injury or damage, do not use steam
cleaning equipment to clean the appliance.
• To avoid short-circuits, ensure no cleaning
water penetrates into the electrical
components when cleaning the appliance.
Do not use a sponge or cloth that is overly
wet.
• Remove all food from the freezer compartment and
store in a cool place temporarily.
• Remove the glass shelves and door racks. Refer to
chapter Equipment.
• Remove the
drawers.
Pull the drawer
straight out, grip at
the back and lift out.
• Clean the inside of the appliance and equipment
parts with lukewarm water and a little detergent.
IMPORTANT
Do not use abrasive or scouring pads or sponges.
Do not use concentrated cleaning agents. Never
use abrasive or acid-based cleaners or chemical
solvents.
• Clean the pull-out rails
with a slightly dampened
cloth only.
IMPORTANT
No cleaning water must be
allowed to get into the pull-
out rail guides.