Installation Instructions
Appliance Installation
Move the appliance towards the final position and leave
enough space to work behind.
Models MRB 3000 and MRB 3600 only
Remove the cover.
Models MRB 3000 and MRB 3600 only
Models MRB 3000 and MRB 3600 only
The water dispenser on models MRB 3000 and
MRB 3600 is connected using a 1/4" compression fit-
ting.
For the water supply, we recommend
braided style ice maker hoses with
1/4" connectors.
To connect a 1/4" copper line, use
a 1/4" compression nut and a metal
compression ring.
To connect a 1/4" PEX line, use a
1/4" compression nut and a plastic
compression ring.
A water line is not supplied with the appliance.
Insert the water line until it comes out
on the appliance rear and pull through.
Connect the other end to the male
connector and tighten.
IMPORTANT
Make sure that the connection is fitted with a seal
and is tight.
Safety Instructions and Warnings
for
Water Connection
• Donotinstallthewaterconnectionwhiletheappli-
ance is connected to an electrical outlet.
• Theconnectiontothewatersupplymayonlybe
made by a trained and licensed plumber.
WARNING!
Connect to potable water supply only.
Water Connection Requirements
• Thewaterpressuremustbeintherangeof
40-90 psi (2.8-6.2 bar).
Failure to meet these requirements may result in
water dispenser malfunction and a water leak that
can damage flooring and surrounding furniture.
• Ashut-offvalvemustbeinstalledbetweenthewater
line and the main water supply. It must be eas-
ily accessible so the water supply can be stopped
immediately if necessary.
IMPORTANT
Do not install the shut-off valve behind the appliance.
IMPORTANT
Do not use any old or already premounted water
supply lines.
10
I
nStallatIon