Designer Guide

42 43
Toe Kick and
Ventilation Requirements
All Monolith ventilation takes place through the Toe
Kick area. Door panels must be a minimum of 4" above
the fl oor. Do not block grill in Toe Kick area.
Liebherr off ers a 4" (102 mm) tall Toe Kick matching
the width of the Monolith columns, and possible
Side-by-Side combinations, as an accessory.
Please refer to page 35 for Toe Kick accessories
ranging from 18" to 72" width.
The Monolith appliance comes with dividers that must
be installed on the appliance and onto the door, in
order to separate the warm exhaust air from the fresh
incoming air.
Door Clearance Requirements
It is fundamental that the Monolith appliances are
installed so the doors (including handles) and adjacent
cabinets, countertops, walls, or other kitchen elements
do not collide with one another when doors open.
In case the door hits the wall or other cabinetry,
a door limiter of 90° is available, please contact
an authorized Liebherr service provider.
Additional solutions include:
• Reduce the door panel thickness if it is larger
than 3/4" (19 mm).
• Rearrange the element that is colliding with the
appliance.
• Use a bumper or stopper to prevent the door from
damaging the adjoining wall or cabinet.
Panel clearance
Frameless installation style
Panel thickness 3/4"
Top view
A = 3/4" gable
B = Front panel door closed. 5/16" (8 mm) overlapping.
Dash line shows an overlapping of 7/8" (22 mm).
This overlapping is solely if the appliance is at the end of a line of cabinets.
C = Front panel 90°
D = Front panel at max. door opening angle of 115°
IMPORTANT
The gap between the appliance front panel and the surrounding furniture panels
must be at least 1/8" (3 mm).
A = Appliance housing
B = Front panel door closed
C = Front panel 90°
D = Front panel at max. door opening angle of 115°
Panel clearance
Panel thickness 3/4"
Top view