Installation Instructions

Fasten the appliance in the
recess - Figure 20
Fasten the appliance in the recess through the upper
and lower hinges of the refrigerator doors.
Use 2 screws for each hinge.
screws
(4 x 16 mm)
Before mounting the door panels
- Figure 21
Remove cover
1
and unscrew the upper attachment
bracket
2
of both refrigerator doors. These brackets
will be mounted onto the refrigerator door panels.
IMPORTANT
The nuts are needed to fit the premounted
panels onto the refrigerator doors.
Figure 20
Figure 21
Leveling the Appliance - Figure 18
1. Adjust the height of the
appliance at the front
by twisting the leveling
feet
1
(A/F 27).
Use the open-ended
spanner provided.
2. Adjust the height of the
appliance at the rear
by turning the adjusting
bolts
2
.
3. Rotate leveling feet
1
until firmly in place
against the floor.
To prevent the appliance from tipping
forward the leveling feet 1 (Figure 19)
must have contact with the floor.
Figure 18
Adjusting the front of the drawer
- Figure 19
If required, the front of the freezer drawers can be
adjusted.
Transfer the screws shown in the illustration (on the left
and right sides of the freezer drawer) individually to the
long slots below.
Tighten the screws in the front of the drawer once it is in
the right position.
Side view of the freezer draw-
er pulled out
Figure 19
12
InStallatIon